hardware

Set of 10 black metal turn buttons w/screws. 5/8" long.
Tips are turned up for easy of use tho I'm sure they could be hammered flat if desired.
13 available

H2 D-ring Hangers

Set of 4 D-ring hangers with screws. 5/8 x 1-3/8" & 1/2" screws.
Good for heavy pieces & allows hanging directly on nails or hooks, without needing
to use wire (can also be used with wire)
12 available

H3 Decorative Hanger

1" wide x 1-1/8"tall Screw into the top of a picture & hang with a velvet ribbon, screw into the bottom of a piece to dangle objects, use as small handles on a box or shrine, etc. Old stock so may have some cosmetic issues. Sold per pair.
5 available

H4 Vintage Knob Plate

Antique brass with flower & leaf pattern. 1-3/4" in dia. x 3/4"thick. Hole goes all the way through for cording, ribbon, metal or wood dowels etc. Can be screwed to a door or drawer, used as a headpiece for a doll ... Sold per piece.
9 available

H5 Vintage Knob Plate

Vintage metal with flourish pattern. 1-3/8" in dia. x 5/8"thick. Hole goes all the way through for cording, ribbon, metal or wood dowels etc. Can be screwed to a door or drawer, used as a headpiece for a doll ... Sold per piece.

Sold Out

H6 Black Beaded Handle

Vintage metal with beaded edge. 4" long x 5/8" wide x 3/4" tall. Can be screwed to a door or drawer, use as a handle for a shrine, small cabinet or box. Surface grunginess will vary
3 available

H7 Antiqued Bronze Handle with Back Plate

Antique metal handle with back plate. 4-5/8" long x 9/16" wide x 1" tall. Back plate is 6" long x 7/8" wide x 1/8" thick. Use together or separately. Can be screwed to a door or drawer, used as a handle for a shrine, small cabinet or box, etc.
4 available

H8 Vintage Mail Box Doors

3-3/4 x 5 x 1". Fits into opening 3-1/4 x 4-1/2 to 4-3/4", four tabs on the back are for attaching to opening. The glass & the numbers in the bottom panel can be removed
&/or replaced. With a little ingenuity, one could figure out a way to rig them so they can be used as an operable door.

These weigh about a pound so I've tacked on an extra shipping charge. Any unnecessary overages will be refunded.
(Photos of the back side below)

Temporarily out of stock

Views of the back side

canvas clips

12 Offset Canvas Clips with Screws

These are used in the picture framing business to hold artwork (canvases) into frames (see diagram below) Of course they can be used in other ways like holding thick glass or wood panels behind an opening. Attaching things this way would be reversible. They measure 1/2" wide x 1" long with an offset of 1/4 in or 1/8 in. (can be hammered a little flatter if needed) Can also be flipped upside down to hold the item in as well.

Beads Collage Sheets Containers Doll Parts Electronica Ephemera Glass/Acrylics Hardware Metals Miscellanea Mounting Supplies Odds & Ends Papers PinkPaislee Ribbon Rub On Transfers Wood